Phone: (508) 875-8662 Fax: (508) 875-0145, Email: hoha@charter.net |
| List All Threads/Messages |
Post Message |
Search Messages by Content or Date Range |
|
Hard of Hearing Advocates Home Page Read These Posting Guidelines Feedback on this Message Board / Report Abuse | ||||||
|
Subject : Self Programming my AH ADRO aids - a problem posted by Dave_s on Sun May 22, 2011 1:20 pm |
| I always preset the ADRO volume controls to 2.5 both sides before reprogramming. When my ADROs are connected to the programmer I adjust so that hearing is reasonably understandable and just loud enough. Next, I program the ADROs and disconnect. The problem occurs when my ADROs are disconnected and reset (Power off then power on). Now I should be able to hear as well when disconnected and reset as I heard when connected to the ADRO programmer. But that is never the case. When disconnected, sounds are a little muffled or distorted. Increasing the volume control to 3.5 or almost 4 causes more clarity, highs increase, less muffling but all sounds become too loud. Is most frustrating. Any comments will be appreciated Dave_s |
| Show All Messages in thread | Email Notification | Post a followup message |
| << Previous thread | Next thread >> |
Phone: (508) 875-8662 Fax: (508) 875-0145, Email: hoha@charter.net |
